Emtech-electronics BLU-CC Manual do Utilizador descarregar pdf

BLU-CC2 Remote Control

BLU-CC Wiring Instructions

IMPORTANT: CAT5e wiring for the RJ-45 connector needs to be

crimped to TIA/EIA 568B Standards (see below) on both ends of the cable.

You must crimp and test the wiring with an approved CAT5 568A/B

tester before connecting any cable between the BLU-CC and either a

BLU-CIF or BLU-IF Interface unit. Failure to crimp wiring to the correct

standard could possibly lead to component damage.

EIA/TIA568B

1. White-Orange

2. Orange

3. White-Green

4. Blue

5. White-Blue

6. Green

7. White-Brown

8. Brown

The BLU-CC2 is a 3-input (3-mic or

2-mic & 1-transformer balanced stereo

to mono line input) remote control for

BSS Audio London Series Digital

Signal Processors. It is housed in a 3-

gang wall mountable box with a

latching door. On the backside of the

control, there is a pair of RJ-45 Cat5e

connectors for connecting the BLU-

CC2 to the DSP, and a 3-pin Euro-

block for the audio signal from either

Mic 3 or the Aux Inputs (RCA or

3.5mm) to the DSP.

1 2 3

BLU-CC2 Remote Control BLU-CC Wiring Instructions IMPORTANT: CAT5e wiring for the RJ-45 connector needs to be crimped

In addition to adding a 3.5mm stereo jack to the AUX Inputs section of the BLU-CC2, there is a switch on the upper back of the board for setting up t

There is a green LED located on the backside of the BLU-CC.

Sem comentários

Emtech-electronics BLU-CC Manual do Utilizador